|
|
 |
| You are not authorized to post a reply.
|
|
| Author |
Messages |
|
Tangerine_Stripes
Posts:334
Location: Fort Worth
 |
| 10/14/2008 9:39 AM |
 Alert
|
Bowtie Block, Scat Crank, Eagle rods, J/E forged pistons, hellfire rings. Motor is 10.5 to 1 compression ratio.
Comp Cams solid roller, .775 int. lift, .748 exh. 284 int.dur @.050 292 exh. dur @.050.
Comp Cams roller lifters
GM Performance Signature series aluminum heads
O ringed block with copper head gaskets
Completely Studded throughout with ARP studs
2.25 stainless intake valves, 1.88 stainless exhaust valves
Comp Cams pro magnum rocker arms
Holley Strip Dominator (4150) port matched
Nice Stefs aluminum oil pan
ATI Super dampner
Short aluminum mechanical water pump
SFI Approved flexplate
Complete motor, add your carb, valve covers and distibutor and go! Nice street motor, or would make a good T/S motor as well, has less than 100 street miles and a few passes at the track. Motor was built for a 300-400 shot of nitrous. Went 6.30's in a 3280 lb car without nitrous. Put this motor in Mom's street 55 Chevy, she wants to go back to her mild 468 with some fuel injection and A/C!!! Hot rod motor has got to go! You can hear it run as it will be in the car until sold. I will even take you for a ride if needed.
$6400.00 OBO!!!! Need this motor gone, somebody make a reasonable offer!
Thanks, David 817-966-3098, 214-938-7362
|
|
THE Mightiest of Mouses |
|
|
Tangerine_Stripes
Posts:334
Location: Fort Worth
|
| 11/04/2008 9:13 AM |
Alert
|
| SOLD |
|
THE Mightiest of Mouses |
|
|
|
| You are not authorized to post a reply. |
|
|
|
ActiveForums 3.6
|
|
|
|
|